Numerical Simulation Study on the Technology of Different Nature Polymer Injection in Thin and Bad ReservoirNumerical Simulation Study on the Technology of Different Nature Polymer Injection in Thin and Bad Reservoir

Wenlong ZHANG, Liyan SUN, Xiaotong ZHANG, Jian WANG

Abstract


The thin and poor reservoir , as an important replacement of production decline in the later stage of oilfield development, is gradually becoming the target of three oil recovery due to the large proportion of its reserves. For Class Ⅲ and Class Ⅳ of thin and poor reservoirs with large contradiction between the layers, if the same molecular weight polymer flooding is used to drive oil, it is easy to affect the development effect because of low producing degree of poorly matched reservoir. On the basis of the fine geological model, the water cut and cumulative oil production of the simulated area were fitted by the simulation software of eclipse, and  the development effect of different production schemes is analyzed and forecasted. Research results show that the effect of different layer different nature polymer injection is better than that of general polymer injection, and the effect of different stage different nature polymer injection is better than that of the different layer different nature.

Keywords


Thin and bad reservoir; Numerical simulation; Different nature and different stage; Polymer flooding

Full Text:

PDF

References


[1] Zhang, X. Q., Guan, H., & Wang, H. T. (2006). Development practice of polymer flooding in class Ⅲ reservoirs of Daqing oilfield. Petroleum Exploration and Development, (3), 374-377.

[2] Zhang, Y. H., Zeng, X. M., & Wang, W. W. (2011). Numerical simulation of polymer flooding in class Ⅲ reservoirs of Daqing oilfield. Fault-Block Oil and Gas Field, (2), 232-234.

[3] Li, J. (2003). Study on the distribution of remaining oil after polymer flooding in the main oil reservoir of Daqing oilfield. Daqing Petroleum Institute, China.

[4] Guan, H. (2006). Study on adaptability of polymer flooding in three types of oil reservoirs in Daqing oilfield. Daqing Petroleum Institute, China.

[5] Mu, W. Z. (2006). Numerical simulation study of viscoelastic polymer flooding. Daqing Petroleum Institute, China.

[6] Guo, J. Y. (2014). Research on the 2nd phase chemical flooding numerical modeling in the central west region of SZ after tertiary infilling and EOR technology. Northeast petroleum university, China.

[7] Zhang, Y. G. (2008). Optimization method research on reservoir parameter interpretation in SZ thin and low productivity development region. Daqing Petroleum Institute, China.




DOI: http://dx.doi.org/10.3968/8364

Refbacks

  • There are currently no refbacks.


Copyright (c) 2016 Advances in Petroleum Exploration and Development

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

Share us to:   

Reminder

 We are currently accepting submissions via email only.

The registration and online submission functions have been disabled.

Please send your manuscripts to aped@cscanada.net，or  aped@cscanada.org  for consideration. We look forward to receiving your work.

 

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:
caooc@hotmail.com; aped@cscanada.net; aped@cscanada.org

 Articles published in Advances in Petroleum Exploration and Development are licensed under Creative Commons Attribution 4.0 (CC-BY). 

ADVANCES IN PETROLEUM EXPLORATION AND DEVELOPMENT Editorial Office

Address:1055 Rue Lucien-L'Allier, Unit #772, Montreal, QC H3G 3C4, Canada.

Telephone: 1-514-558 6138
Website: Http://www.cscanada.net
Http://www.cscanada.org
E-mail:office@cscanada.net;  office@cscanada.org

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures